Metal roofs last a long time, but screws loosen, washers wear out and trim can work free. ATech tightens up metal roofs on homes, barns, cabins and shops.
A metal roof can protect a building for decades, but it isn't maintenance-free. Panels expand and contract with every hot afternoon and cool night, and over the years that movement loosens fasteners and wears out the rubber washers that seal them. Trim, ridge cap and flashing can also shift or lift in high winds.
ATech repairs metal roofs on homes, barns, cabins, carports and workshops throughout Jefferson County and East Tennessee. We replace worn or backed-out screws, re-secure loose panels, reseal laps and seams, and repair the trim and flashing around chimneys, vents and walls.
Tammy will walk the roof, show you exactly where water is getting in and give you a straightforward price to get it sealed back up.
These are the trouble spots we check first on every metal roof.
Screws that backed out or washers that cracked, letting water in at every hole.
Panels lifted by wind or movement, re-secured so they lie flat and tight.
Overlaps where sealant has dried out, cleaned and resealed.
Ridge cap, rake trim and penetration flashing repaired or replaced.
On a metal roof, most leaks come from hundreds of small openings rather than one big one. A roof with thousands of fasteners only needs a few of them to fail before you start seeing drips in the barn or water spots on the ceiling.
Replacing worn fasteners and resealing seams is far cheaper than replacing panels, and it can add many years to a metal roof's life. On barns and shops, it also protects the equipment, hay or vehicles inside.
We'll tell you whether your metal roof needs a targeted repair, a full re-screw or something more — and we won't recommend more than it needs.
Here's what to expect when ATech repairs your metal roof.
The rubber washers under each screw break down from sun and temperature swings, and screws can loosen as the panels move. Replacing them with new fasteners usually solves it.
Yes. We repair metal roofs on barns, sheds, carports and workshops, as well as homes, cabins and lake houses.
Often, yes. If a panel is dented, rusted through or torn, we can usually replace it without redoing the whole roof.
On older metal roofs with widespread fastener failure, a full re-screw can be the best value. We'll look and give you an honest recommendation.
Surface rust can often be treated and sealed. If a panel has rusted through, it's usually better to replace that section.
From your first phone call to the final cleanup, here's exactly what to expect when you hire ATech Roofing and Seamless Gutter.
Call 865-307-7141 or request online. Tammy will come out — often the next day — measure, answer your questions and give you a fair price, free.
We look over the whole system, explain what we find and recommend only what your home actually needs — no unnecessary replacements.
The work gets done fast — often within days — with nearly 30 years of experience behind it and often photos of the finished job.
We clean up so thoroughly you'd never know we were there — not one nail or scrap of trash left behind.
Family-Owned • Nearly 30 Years of Experience • Free Estimates • Roofing & Seamless Gutters • Serving Dandridge & East Tennessee